|
|
| |
| Power Monitor Sensor |
| |
|
|
• Preisliste zusenden
• Anfrage |
| |
| |
Power Monitor Sensor
The ability to remotely monitor power provides savings in both man hours and downtime. Remote monitoring capabilities eliminate the need for manual power audits as well as provide immediate alerts to potential problems. The Power Monitor Sensor is specifically designed to be used with AKCP’s Linux products including the latest line of securityProbe units. Combining the Power Monitor Sensor and securityProbe creates a fully IP enabled power monitoring product. As with all other AKCP
intelligent sensors it is “plug and play” with the securityProbe unit automatically detecting the sensor type and configuring the web interface accordingly. Users can be alerted on the sensor exceeding a pre-defined threshold with AKCP’s industry leading notification options like: SNMP traps, email, SMS, MMS and the recently released Skype support.
Data collected over time using the Power Monitor Sensor can also be viewed using the securityProbe’s built in graphing tool and can be exported to external applications for analysis.
The Power Monitor Sensor is a multifunctional power meter capable of measuring RMS voltage and RMS current and energy usage in Watts on a single phase power line. The sensor can work with either 110V or 220V supply voltages. On 220V it can measure RMS voltage between 200 to 260 Volts and RMS current between 0 to 30A. On 110V it can measure RMS voltage between 95 to 125 Volts and an RMS current between 0 to 30A. The resolution of the power sensor is 0.1A for measurements of RMS current
and 1V for RMS voltage. The energy meters can measure active energy usage in Watts and Watt-Hour.
Specifications & Features:
Supply Voltage: 110V or 220V
Measurements:
- RMS Voltage on 220V: 200 to 260 VRMS
- RMS Current on 220V: 0 to 30A
- RMS Voltage on 110V: 95 to 125 VRMS
- RMS Current on 110V: 0 to 30A
- Active and apparent power (Watt and Watt-Hour)
Resolution: 0.1A for measurement of RMS current and 1V for measure RMS voltage.
Communications cable: UTP CAT 5 wire.
Measurement rate: one reading every second.
Up to 8 power monitor sensors per securityProbe
Full autosense including disconnect alarm
Power source: sensor powered by measured power point
Dimensions: 195 x 145 x 100mm
The sensor comes with:
a CAT5 cable 5 feet in length. This cable can be extended to up to 100ft maximum.
3ft power in- and output cable |
|
|
